A look around our new shop!
Some stills around the new shop!
RS6 Snaps
It’s just about finished. After months of engine headaches we finally have the built motor and rebuilt turbos in the car. It’s running great and the customer finally has it back. After we get a good break-in we’ll start pushing the tune and see what we can really get out of it. Here are some [...]
E46 M3 Muffler Section
This is the muffler section of the custom exhaust we did for Jose’s M3. We did a full 3 1/2 inch midsection out to this muffler setup. It probably has enough capacity to support double the current power output but the goal was a deep tone without any rasp. It sounds great. Next to M.Burroughs’ [...]
blog
- TGIFMUIt’s Friday. Despite what Rebecca [...]
- Erick’s SL65 AMG On The Dyno!The following video is meant to [...]
- From The Ground UpSometimes you need to work a [...]
- Placement Is KeyIf you didn’t check out yesterday’s [...]
- Pro TipsWe at Fluid MotorUnion tend to [...]
- More blog
Category
Blogroll
- Extrude Hone Fluid MotorUnion is an official dealer for ExtrudeHone. ExtrudeHone uses the Abrasive Flow Machining (AFM) process to smooth internal passage ways and provide exceptional air/fuel flow for increased volume and velocity.
- Jalopnik Obsessed with the Cult of Cars
- Speedhunters Car Culture from across the globe
- StanceWorks Low is a Lifestyle
